DECADE (TS-190) APPLICATION INSTRUCTIONS (6/12/10)

 

This information has been prepared for use with Decade Deck Paint on properly prepared surfaces. All surfaces must be thoroughly clean, free of mold, mildew, algae and other contaminates. Wood must be thoroughly dry before application. Since materials and previously applied paint, sealers and stains vary we recommend doing a test patch area applied and allowed to cure for 72 hours before applying Decade Paint or primer to an entire deck. DO NOT apply Decade over water repellant sealers which will prevent proper adhesion. When wood has been sealed use an oxalic acid-based cleaner to remove the sealer in its entirety. Sanding is recommended but not required as surface conditions permit. Decade can be used over dimensional decking materials including Pine, Cedar, Redwood, Fir, Cyprus, Pressure Treated woods and synthetic decking materials without primer, however Decade Primer (TS-180) is often used to promote adhesion and provide a sound base. Steel, fiberglass aluminum must be primed with an Etching Primer; call us for details. Do not apply when rain is forecast within 48 hours. Never paint above 85F, in hot direct sunlight or when humidity is forecasted to be at or above 75%. Best results will be obtained by roller-coat but Decade is brushable and may be sprayed.

 

1. REPAIRS: All repairs should be completed and allowed to cure prior to cleaning, sanding or the application of Decade paint. Be sure all repair materials are paintable before use.

 

2. STRIPPING & CLEANING: Peeling paint may be removed using TS-646 Triple Strength Paint Stripper according to label directions. For best results recommend sanding (150-220 grit) which promotes adhesion. When applying over sound prepared paint recommend using Decade Yearly Cleaner (TS-685) as a pre-paint cleaner according to label directions. Yearly Cleaner removes dirt, grime, grease, wax and oil. Rinse carefully and allow to dry thoroughly.

 

3. PRIMER: Decade is self-priming in one coat, so Decade Primer (TS-180) is optional. It is used to promote adhesion and provide a sound base improving color consistency.  Mix primer thoroughly before use. Apply one coat using a 3/8” non-shedding roller cover at a rate of 150-200 square feet per gallon. Allow to dry 12- 48 hours before over-coating, sand after 72 hours.  

 

4. ADD PRO-TEX NON-SLIP: Pro-Tex is a wax-based pour-in additive that produces a slip resistant finish. Its use is optional. When adding Pro-Tex to Decade Paint; pour in 16 ounces (1 pack) to one gallon. Stir container for 2 minutes with a stir stick or for 1 minute with a high speed mixer.

 

5. APPLYING DECADE PAINT: Mix contents thoroughly. Apply one coat evenly using a 5/8”-3/4” roller cover at a rate of 100 square feet per gallon. NOTE: Apply evenly avoiding ponding. Allow to dry 24 hours before allowing foot traffic. IMPORTANT: Keep dry for 48 hours.

 

NOTE: Recommend applying maintenance coats as needed according to above directions. Dry and cure times vary with the weather, temperature, thickness of application and color. Allow extra dry and cure time for dark colors. Concrete surfaces must be treated with TS-695 Etching Cleaner, muriatic acid or the equivalent. The maximum moisture content for concrete and masonry is 10% with less than 4% hydrostatic pressure. We recommend using the VaporGuage calcium chloride moisture test to establish actual vapor transmission and pH. Failure to adhere to all recommendations voids the Decade 50 Year Limited Warranty so please be sure to follow Application Instructions, label directions, and standard industry practices carefully. We are available to answer questions at 360-651-9050 M-F 8 AM to 5 PM PST.